2x80A Motor Controller

This beast of a motor controller is ready to proportionally control the speed and direction of your brushed DC motors!

Each of the two channels can handle 80A continuously and up to 200A peak! The 43mm width coincides perfectly with the inside width of goBILDA® Channel for ease of mounting. Whether you fasten it from the sides using the threaded holes, or utilize the thru-holes and mount it to a flat surface, the required hardware is conveniently provided with the motor controller so that you can attach it how you’d like.

Power Input:
Supply anywhere between 9 - 30V to the XT90 connector to power your motors. The voltage you provide to the motor controller will be passed on to the motor(s) that you intend to control.

Signal Input:
Plug an R/C receiver, Arduino, or any source of a standard PWM signal into the Channel 1 and/or Channel 2 ports. We’ve provided male-to-male servo extensions to make wiring clean and simple. The beefy BEC will supply 6V and 6A out to the device generating the PWM signal via the + pins so that you can drive servos and other devices from any remaining available channels on your servo controller.

Output:
Each channel of the motor controller can handle up to 80A! You can plug in motors (as many as you’d like) to each of the two channels, so long as you do not surpass the current limit of that channel. This motor controller comes with bullet connectors: you can solder them onto the wires of your motor, or build a harness to supply power to multiple motors.