Shop By Product

56312 Hitec OEM Replacement Gear Set

1 of 1

Be the first to review this product

In stock
This Product? Share It!


Replacing your broken or worn out servo gears is very easy but you need to pay attention when opening your servo. Most servos have four main gears. These gears need to be put in the proper order for the servo to work correctly. Not only is the order important but also the mounting of the final gear (the one that is attached to the output shaft) onto the potentiometer. The “pot” is a flattened shaft that the final gear sits on. This flat spot is easily visible on standard size or larger servos. Make sure that this flat spot fits with the flat cutout in the final gear or your servo may not operate correctly.

Note: Nylon geared servos will accept metal gears of their equivalent. Example: HS-81 nylon geared servo will accept HS-81 metal gears. Also Be sure to grease your replacement gears when you install them.

Servo Compatibility HS-60

Product Tags

Use spaces to separate tags. Use single quotes (') for phrases.

Connect With Us
Shop Secure

As Featured In

Copyright 1999-2020 Robotzone, LLC - All rights reserved. ServoCity® is a registered trademark of Robotzone, LLC.