Shop By Product

Actobotics Servo Hub Shafts

Patented
Patented
  • shown mounted on a <a href="/servos/hitec-servos">Hitec servo </a>
  • Patented
  • shown mounted on a standard <a href="/servos/futaba-servos">Futaba</a> servo
  • used in our <a href="/servos/servoblocks">ServoBlocks</a>
1 of 5
This Product? Share It!

Details

A Servo Hub Shaft is one of several integral parts of a ServoBlock.  The 0.80" long shank provides ample room to run a 1/2" bore bearing around it to isolate radial load from being applied directly to the spline of your servo.  The top of the Servo Hub Shaft is 1" in diameter and possesses the Actobotics 0.770" hub pattern (8 x 6-32 threaded holes) so that other Actobotics components can easily be attached.  The center bore provides easy access to allow you to install the stock servo screw which will hold the Servo Hub Shaft down onto the servo.  Servo Hub Shafts are offered with the 24 Tooth (C1) Spline or the 25 Tooth (3F/H25T) Spline which means they're compatible with most servo brands on the market.  Patented.

Actobotics Servo Hub Shafts
SKUServo SplineWishlistPricePurchase
52512224 Tooth Spline
Add to Wishlist
52512325 Tooth Spline
Add to Wishlist
SPECS

Actobotics Servo Hub Shaft

Product Weight 0.35 oz
Material Aluminum
Hole Pattern 0.770"
Servo Spline Compatibility 24 Tooth (C1) Spline or 25 Tooth (3F/H25T) Spline
RESOURCES

Product Tags

Use spaces to separate tags. Use single quotes (') for phrases.

Connect With Us
Shop Secure

As Featured In

Copyright 1999-2018 Robotzone, LLC - All rights reserved. ServoCity® is a registered trademark of Robotzone, LLC.