Shop By Product

Electronic PWM Controlled Dual Relay (12A)

  • top view
1 of 2

Be the first to review this product

Part
RCE220
RCE220
Status
In stock
This Product? Share It!

Details

Switch two relays on and off with an R/C system or servo controller! Normally open and normally closed solder points are provided for each relay. You can drive two independent motors, contactors or pneumatic/hydraulic solenoids. Plus a simple wiring configuration also converts this to a mechanical H-bridge which is perfect for running a single linear actuator or motor in both forward/off/reverse. When used with one of our actuators, optional inputs from limit switches permit you to arrest motion in either direction. The silver cadmium oxide relay contacts offer you a maximum motor/coil load of 12 amps at 30 VDC (inductive). Fault detection safely switches off both relays if receiver signal is lost. Complete instruction manual found here.
SPECS

Uses a PWM signal to control SPDT relays.

Product Weight 1.4 oz
Throw Persistence Momentary
Max Current 12A
Max Voltage 30VDC
Switch Style PWM
Mounting Style Secured by four #6 machine screws to a flat surface
RESOURCES

   

Download Attachment
pdfUser Manual(74.94 KB )Download

Product Tags

Use spaces to separate tags. Use single quotes (') for phrases.

Connect With Us
Shop Secure

As Featured In

Copyright 1999-2017 Robotzone, LLC - All rights reserved. ServoCity® is a registered trademark of Robotzone, LLC.