Shop By Product

C1 Spline Actobotics Servo Arm

  • countersunk holes
  • shown mounted on a <a href="/servos/hitec-servos">Hitec servo </a>
  • shown mounted on a <a href="/servos/hitec-servos">Hitec servo </a>
1 of 4

Be the first to review this product

Part
525116
525116
Status
In stock
This Product? Share It!

Details

The Actobotics Servo Arm is broached to fit on any Hitec servo with a standard 24 tooth (C1) spline using your stock servo screw.  The horn is machined from 1/4" thick aluminum and contains three 6-32 tapped holes equally spaced 0.385" from one-another.  These holes are counterbored from the underneath side (spline side) of the horn so that a socket head screw can be threaded in from the bottom up and tighten down, leaving the head of the fastener completely concealed within the part.  This setup is desired when used with a ball linkage to minimize slop.  Alternatively, a screw can be threaded in from the top if you have an application that requires a mating component to be hard-mounted and you want to minimize the pieces of hardware used.  

SPECS

525116

Product Weight 0.10 oz
Material Aluminum
Spline Size 24 Tooth (C1) Spline
RESOURCES

Product Tags

Use spaces to separate tags. Use single quotes (') for phrases.