Shop By Product

Actobotics Standard Hub Horns

  • shown mounted on a <a href="/servos/hitec-servos">24T Hitec servo </a>
  • shown mounted on a <a href="/servos/hitec-servos">25T Hitec servo </a>
  • shown mounted on a <a href="/servos/hitec-servos">Hitec servo </a>
  • shown mounted on a <a href="/servos/hitec-servos">Hitec servo </a>
1 of 8
This Product? Share It!

Details

A Standard Hub Horn allows you to fasten nearly any Actobotics component to the top of your servo.  The hub horns possess the Actobotics 0.770" Hub pattern, 4 holes are 6-32 tapped and 4 are thru hole (0.140" dia.) so that screws can be inserted up from the bottom into a threaded component.  The 1/4" thickness and 1" outside diameter provides ample clamping surface if you wish to clamp a component on with a hub so that you can easily index or remove the part(s).  The center of the Standard Hub Horn is recessed so that when the stock servo screw is installed, it won't protrude above the top surface of the hub horn.  The Standard Hub Horns are offered with the 24 Tooth (C1) Spline or 25 Tooth (3F/H25T) Spline which means they're compatible with most servo brands on the market.  

Actobotics Standard Hub Horns
SKUSpline SizeWishlistPricePurchase
52513024 Tooth
Add to Wishlist
52513225 Tooth
Add to Wishlist
SPECS

Actobotics Standard Hub Horn

Material Aluminum
Hole Pattern 0.770"
Servo Spline Compatibility 24 Tooth (C1) Spline or 25 Tooth (3F/H25T) Spline
RESOURCES

Product Tags

Use spaces to separate tags. Use single quotes (') for phrases.

Connect With Us
Shop Secure

As Featured In

Copyright 1999-2019 Robotzone, LLC - All rights reserved. ServoCity® is a registered trademark of Robotzone, LLC.