Shop By Product

0.375" x 1.00" Servo Shafts

  • Patented
  • non-spline side
  • 525140 mounted on a <a href="/servos/hitec-servos">Hitec servo </a>
  • 525142 shown mounted on a standard <a href="/servos/futaba-servos">Futaba</a> servo
1 of 5
This Product? Share It!

Details

This 0.375" OD, 1" length Servo Shaft is able to fasten directly to a servo with by installing the stock servo screw down through the hollow bore of the shaft and into the servo spline.  The 0.375" outside diameter provides an excellent surface to install a bearing onto in order to isolate radial load from being applied directly to the spline of you rservo.  To fasten components onto the servo shaft you can then install a 3/8" clamping hub to provide a non-marring, super strong connection.  By using the combination of this servo shaft and a clamping hub you can easily index the mating component or remove it and re-install it without having to remove any fasteners - just loosen the pinch bolt on the clamping hub.  The 0.375" Servo Shafts are offered with the 24 Tooth (C1) Spline or 25 Tooth (3F/H25T) Spline which means they're compatible with most servo brands on the market.  Patented.

0.375" x 1.00" Servo Shafts
SKUServo SplineWishlistPricePurchase
52514024 Tooth Spline
Add to Wishlist
52514225 Tooth Spline
Add to Wishlist
SPECS

0.375" x 1.00" Servo Shaft

Material Aluminum
Servo Spline Compatibility 24 Tooth (C1) Spline or 25 Tooth (3F/H25T) Spline
RESOURCES

Product Tags

Use spaces to separate tags. Use single quotes (') for phrases.

Connect With Us
Shop Secure

As Featured In

Copyright 1999-2020 Robotzone, LLC - All rights reserved. ServoCity® is a registered trademark of Robotzone, LLC.