Shop By Product

0.500" x 1.00" Servo Shafts

  • Patented
  • 525128 shown mounted on a <a href="/servos/hitec-servos">Hitec servo </a>
  • 525129 shown mounted on a standard <a href="/servos/futaba-servos">Futaba</a> servo
  • non-spline side
1 of 4
This Product? Share It!


This 0.500" OD, 1" length Servo Shaft is one of several integral parts of a ServoBlock.  The 0.500" outside diameter provides an excellent surface to install a bearing onto in order to isolate radial load from being applied directly to the spline of your servo.  To fasten components onto the servo shaft you can then install a 1/2" clamping hub to provide a non-marring, super strong connection.  By using the combination of this servo shaft and a clamping hub instead of the Actobotics Servo Hub Shaft, you can easily index the mating component or remove it and re-install it without having to remove any fasteners - just loosen the pinch bolt on the clamping hub.  The center bore provides easy access to allow you to install the stock servo screw which will hold the servo shaft down onto the servo.  The 0.500" Servo Shafts are offered with the 24 Tooth (C1) Spline or 25 Tooth (3F/H25T) Spline which means they're compatible with most servo brands on the market.  Patented.

0.500" x 1.00" Servo Shafts
SKUServo SplineWishlistPricePurchase
52512824 Tooth Spline
Add to Wishlist
52512925 Tooth Spline
Add to Wishlist


0.500" x 1.00" Servo Shaft

Material Aluminum
Servo Spline Compatibility 24 Tooth (C1) Spline or 25 Tooth (3F/H25T) Spline

The Servo Shaft Attachment also works in conjunction with our ServoBlocks.

Product Tags

Use spaces to separate tags. Use single quotes (') for phrases.

Connect With Us
Shop Secure

As Featured In

Copyright 1999-2020 Robotzone, LLC - All rights reserved. ServoCity® is a registered trademark of Robotzone, LLC.