4 Channel Boosted Servo Extension via CAT6

SKU: Build System: goBILDA
$24.99

This Boosted Servo Extension lets you control up to four servos over a CAT6 cable. This approach allows you to control your servos from a distance with the rock-solid connectivity of a wired setup. It can control up to four servos at once, making it useful if you need to tidy up the wiring on your project. Includes 1 Sending Board w/case, 1 Receiving Board w/case, and 4 servo extensions.

Compatibility

Ethernet Cables: While CAT6 is the recommeded cable, the RJ45 connector this Boosted Servo Extension uses is also compatible with CAT5, CAT5e, CAT6a, and CAT8 cables.

RC Receivers: This Boosted Servo Extension is compatible with any receiver which uses a PWM signal. This is just about any receiver in the hobby or small-medium robotics industries.

Servos: This Boosted Servo Extension is compatible with any servo which uses a PWM signal. This is just about any servo in the hobby or small-medium robotics industries.

Actobotics Electronics: While this Boosted Servo Extension uses CAT6, it utilizes a newer protocol than the Actobotics CAT6 boards (605102, 605103, 902MSD) making them incompatible with each other.

Specs

Recommended Voltage Range 6V - 15V
Max Voltage Range 3.3V - 18V
Signal Channels 4
Max Current (When powered at Receiving Board) 16A Total (4A per Channel)
Max Current over CAT6 (When powered at Sending Board) 4A Total
Servo Compatibility Analog & Digital
Maximum Recommended Ethernet Cable Length 100ft (30M)
Power Compatibility TJC8, XT30, 3mm Solder Holes

This website uses cookies to ensure you get the best experience on our website